OMAL DAN0030411S - Actuator F03/F05

OMAL AGO - Aluminium double acting DA type - Actuator F03/F05

KEY BENEFITS: - Energized and self-lubricated strips: Less friction between piston and cylinder It prevents the bonding of the seal to the cylinder even after long periods of inactivity - Slots, bushes and pins made by steel with hardness higher than 50 HRC: Higher resistance to the forces inside the actuator - Rolling friction between piston and slot: Less friction - Scotch yoke with rolling friction (transforming rotary motion into linear motion using piston and shaft without teeths/gears): Reduced friction between piston and shaft with consequently less wear on the relevant parts Empowered Breakaway Torque (BTO & BTC) Smaller volume/size than rack and pinion actuators (with the same torque) therefore less space required for installation Less weight than the rack and pinion (-30% kg / Nm), with consequent savings on the construction sizing of the plant/equipment Lower air consumption compared to the rack and pinion actuators (-40% air cm3/Nm for Double Acting and -20% air cm3/Nm for Spring Return) therefore less load on the compressor or the possibility of using a smaller compressor's size. - Rolled cylinder: Less wear of the energized ties thanks to the low roughness of the surface - Stainless Steel shaft: Higher corrosion resistance From sizes bigger than DAN15, NAMUR interface for solenoid valve is already integrated . No need for extra plate. - % in- house manufacturing process technology: Maximum control and accuracy in all the stages of the manufacturing process ATEX Certificate Installation is allowed in a potential explosive environment Up to SIL 3 Certified Guarantee of the high level of functional safety.

TECHNICAL FEATURES: - Torque from 8 Nm to 8000 Nm. - Mounting flange according to EN ISO 5211 - F03 - F04 - F05 - F07 - F10 - F12 - F14 - F16 - F25. - In accordance with EN 15714-3 - Rotation angle: 92° (-1°, +91°) - Torque: directly proportional to the air supply (see table). - The code numbers after the DA/DAN letters, always correspond to the breakaway torque in Nm by 5,6 bar air supply. - ATEX version in conformity with directive 2014/34/EU. Please add - YX at the end of the code for ATEX version.

WORKING CONDITIONS: - Temperature: from -20°C to +80°C. (Special versions: high temperature: -20°C +150°C; low temperature: -50°C +60°) - Air supply: 5,6 bar; maximum 8,4 bar (7 bar for DA8000). - Actuating media: filtered dry compressed air, not necessarily lubricated. - In case of lubricated air, either non detergent oil, NBR compatible oil, must be used.